Chiptuning files » Dodge » Charger » 2006 - 2010 » 5.7i V8 HEMI (345 hp / 525 Nm)

Chiptuning files for Dodge Charger 2006 - 2010 5.7i V8 HEMI (345 hp)

ECU: Motorola NGC4 / Motorola NGC4A / Siemens/Continental GPEC2 / Siemens/Continental GPEC2A

Stock
345 HPstock power
525 Nmstock torque
257 KWstock power

Tuned figures for this engine follow after we have seen your original file.

Available modifications

Immobiliser and cloning

What each modification does
Stage 1 for Dodge Charger 5.7i V8 HEMI (345 hp)
Software-only remap for a car with standard hardware.
Stage 2 BASE for Dodge Charger 5.7i V8 HEMI (345 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us.
Flex fuel mod for E85 or other fuel types for Dodge Charger 5.7i V8 HEMI (345 hp)
The engine adapts to the fuel that is in the tank, from petrol to E85 and any blend in between. This is not a fixed E85 calibration.
Pops and bangs for Dodge Charger 5.7i V8 HEMI (345 hp)
Fuel still injected on overrun ignites in the exhaust and gives the crackle sound. Intensity can be set: soft (burbles), normal, hard or flames.
Hardcut limiter for Dodge Charger 5.7i V8 HEMI (345 hp)
Ignition is cut at the limiter instead of fuel being reduced early, so full power is available to the redline.
VMAX speedlimit on/off higher/lower for Dodge Charger 5.7i V8 HEMI (345 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Dodge Charger 5.7i V8 HEMI (345 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Exhaust flap control/off for Dodge Charger 5.7i V8 HEMI (345 hp)
Exhaust valves can be opened or closed independent of the driving mode. For cars with valves in the original exhaust.
Catalyst off for Dodge Charger 5.7i V8 HEMI (345 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
EVAP off for Dodge Charger 5.7i V8 HEMI (345 hp)
Monitoring of the fuel vapour (EVAP) system is switched off.
AGS off for Dodge Charger 5.7i V8 HEMI (345 hp)
The active grille shutters are switched off in software.
Cylinder On Demand off for Dodge Charger 5.7i V8 HEMI (345 hp)
Cylinder deactivation is switched off so the engine always runs on all cylinders.
Cloning (ECU/TCU) for Dodge Charger 5.7i V8 HEMI (345 hp)
The complete content of one unit is copied to another unit of the same type.
Checksum Correction for Dodge Charger 5.7i V8 HEMI (345 hp)
The checksums of the file are recalculated so the control unit accepts the modified software.
EGT sensor off for Dodge Charger 5.7i V8 HEMI (345 hp)
The first exhaust gas temperature sensor is switched off in software, where the vehicle has one.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 170 credits (€98)
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
Flex fuel mod for E85 or other fuel types150 credits (€210)+ 150 credits (€210)
Pops and bangs70 credits (€98)+ 40 credits (€56)
Hardcut limiter55 credits (€77)+ 55 credits (€77)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Exhaust flap control/off45 credits (€63)+ 45 credits (€63)
Catalyst off40 credits (€56)+ 20 credits (€28)
EVAP off40 credits (€56)+ 40 credits (€56)
AGS off30 credits (€42)+ 30 credits (€42)
Cylinder On Demand off25 credits (€35)+ 25 credits (€35)
Cloning (ECU/TCU)199 credits (€278.60)–
Checksum Correction10 credits (€14)+ 10 credits (€14)

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerBoot, OBD (beta)–
Flashtec CMDOBD, Boot–

Also listed for this vehicle: HP Tuners.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Dodge Charger 5.7i V8 HEMI tuning file

ECU and TCU files for the Dodge Charger 2006 - 2010 5.7i V8 HEMI (345 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Petrol
Stock power
345 hp / 257 kW
Stock torque
525 Nm
ECU
Motorola NGC4, Motorola NGC4A, Siemens/Continental GPEC2, Siemens/Continental GPEC2A

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp