Chiptuning files » Volkswagen » Passat » B5 1996 2005 » 2.5 TDi (180 hp / 370 Nm)

Chiptuning files for Volkswagen Passat B5 1996 2005 2.5 TDi (180 hp)

ECU: Bosch EDC15VM+ / Bosch EDC15VM+2 / Bosch EDC15VM-V6 / Bosch EDC15VM-V6-8Mbit

180 HPstock power
370 Nmstock torque
134 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

Engine performance

Immobiliser and cloning

What each modification does
Stage 1 for Volkswagen Passat 2.5 TDi (180 hp)
Software-only remap for a car with standard hardware. 180 hp to 215 hp and 370 Nm to 425 Nm.
Stage 2 BASE for Volkswagen Passat 2.5 TDi (180 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us.
Hardcut Popcorn limiter for diesel for Volkswagen Passat 2.5 TDi (180 hp)
Hard-cut rev limiter for diesel engines with the typical popcorn sound.
VMAX speedlimit on/off higher/lower for Volkswagen Passat 2.5 TDi (180 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Volkswagen Passat 2.5 TDi (180 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Swirl flaps off for Volkswagen Passat 2.5 TDi (180 hp)
Intake flap operation is switched off for engines where the flaps have been removed.
EGR off for Volkswagen Passat 2.5 TDi (180 hp)
The exhaust gas recirculation valve is switched off in software.
AdBlue off for Volkswagen Passat 2.5 TDi (180 hp)
The SCR / AdBlue system is switched off in software.
MAF off for Volkswagen Passat 2.5 TDi (180 hp)
The engine runs without the air mass meter signal.
Hot start fix for Volkswagen Passat 2.5 TDi (180 hp)
Corrects hard starting with a hot engine.
Boost Sensor Calibration for Volkswagen Passat 2.5 TDi (180 hp)
Calibration for an uprated boost pressure (MAP) sensor.
IMMO_OFF for Volkswagen Passat 2.5 TDi (180 hp)
The immobiliser check is removed from the ECU, so the engine starts without the immobiliser.
Cloning (ECU/TCU) for Volkswagen Passat 2.5 TDi (180 hp)
The complete content of one unit is copied to another unit of the same type.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 160 credits (€84)
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
Hardcut Popcorn limiter for diesel55 credits (€77)+ 40 credits (€56)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Swirl flaps off45 credits (€63)+ 45 credits (€63)
EGR off35 credits (€49)+ 30 credits (€42)
AdBlue off60 credits (€84)+ 60 credits (€84)
MAF off45 credits (€63)–
Hot start fix35 credits (€49)+ 35 credits (€49)
Boost Sensor Calibration55 credits (€77)+ 55 credits (€77)
IMMO_OFF99 credits (€138.60)+ 99 credits (€138.60)
Cloning (ECU/TCU)199 credits (€278.60)–

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerOBD–
Magicmotorsport FLEXBoot, OBD–
Alientech KESS3OBD, Bench–
Alientech PowergateOBD–
Flashtec CMDOBD–

Also listed for this vehicle: Alientech KESSv2, Dimsport New Genius.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Volkswagen Passat 2.5 TDi tuning file

ECU and TCU files for the Volkswagen Passat B5 1996 2005 2.5 TDi (180 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Diesel
Engine code
BDH / BAU
Displacement
2496 cc
Stock power
180 hp / 134 kW
Stock torque
370 Nm
ECU
Bosch EDC15VM+, Bosch EDC15VM+2, Bosch EDC15VM-V6, Bosch EDC15VM-V6-8Mbit

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp