Chiptuning files » Mini » One / One D / Minimalist » R56 2010 - 2014 » 1.6 D (90 hp / 215 Nm)

Chiptuning files for Mini One / One D / Minimalist R56 2010 - 2014 1.6 D (90 hp)

ECU: Bosch EDC16C35 / Bosch EDC17C41 / Bosch EDC17C41 Exx / Bosch EDC17C50

90 HPstock power
215 Nmstock torque
67 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Detuned engine: same hardware as the 1.6D 115 hp, limited in software

Available modifications

What each modification does
Stage 1 for Mini One / One D / Minimalist 1.6 D (90 hp)
Software-only remap for a car with standard hardware. 90 hp to 137 hp and 215 Nm to 314 Nm.
Stage 2 BASE for Mini One / One D / Minimalist 1.6 D (90 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us. 90 hp to 145 hp and 215 Nm to 322 Nm.
Sport displays calibration for Mini One / One D / Minimalist 1.6 D (90 hp)
The power and torque displays are recalibrated to the tuned values.
VMAX speedlimit on/off higher/lower for Mini One / One D / Minimalist 1.6 D (90 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Mini One / One D / Minimalist 1.6 D (90 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Start/Stop System Off for Mini One / One D / Minimalist 1.6 D (90 hp)
Start-stop is switched off by default.
Catalyst off for Mini One / One D / Minimalist 1.6 D (90 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
DPF/OPF/GPF off for Mini One / One D / Minimalist 1.6 D (90 hp)
The particulate filter function (diesel DPF, petrol OPF/GPF) is switched off in software. The filter has to be removed physically first.
Swirl flaps off for Mini One / One D / Minimalist 1.6 D (90 hp)
Intake flap operation is switched off for engines where the flaps have been removed.
EGR off for Mini One / One D / Minimalist 1.6 D (90 hp)
The exhaust gas recirculation valve is switched off in software.
AdBlue off for Mini One / One D / Minimalist 1.6 D (90 hp)
The SCR / AdBlue system is switched off in software.
MAF off for Mini One / One D / Minimalist 1.6 D (90 hp)
The engine runs without the air mass meter signal.
TVA off for Mini One / One D / Minimalist 1.6 D (90 hp)
The throttle valve actuator is switched off in software.
Torque monitoring off for Mini One / One D / Minimalist 1.6 D (90 hp)
Torque monitoring is relaxed so a higher torque does not trigger limp mode.
Readiness ok for Mini One / One D / Minimalist 1.6 D (90 hp)
Readiness monitors are set so the car reports ready at an emission inspection.
Hot start fix for Mini One / One D / Minimalist 1.6 D (90 hp)
Corrects hard starting with a hot engine.
IMMO_OFF for Mini One / One D / Minimalist 1.6 D (90 hp)
The immobiliser check is removed from the ECU, so the engine starts without the immobiliser.
Virginize (ECU/TCU) for Mini One / One D / Minimalist 1.6 D (90 hp)
The unit is reset to an unpaired state so it can be coded to another car. A different service from IMMO_OFF.
Cloning (ECU/TCU) for Mini One / One D / Minimalist 1.6 D (90 hp)
The complete content of one unit is copied to another unit of the same type.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 170 credits (€98)
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Start/Stop System Off40 credits (€56)+ 40 credits (€56)
Catalyst off40 credits (€56)+ 20 credits (€28)
DPF/OPF/GPF off50 credits (€70)+ 35 credits (€49)
Swirl flaps off45 credits (€63)+ 45 credits (€63)
EGR off35 credits (€49)+ 30 credits (€42)
AdBlue off60 credits (€84)+ 60 credits (€84)
MAF off45 credits (€63)–
TVA off40 credits (€56)+ 40 credits (€56)
Readiness ok45 credits (€63)+ 15 credits (€21)
Hot start fix35 credits (€49)+ 35 credits (€49)
IMMO_OFF99 credits (€138.60)+ 99 credits (€138.60)
Virginize (ECU/TCU)99 credits (€138.60)–
Cloning (ECU/TCU)199 credits (€278.60)–

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerBench, Boot, OBD–
Magicmotorsport FLEXBench, Boot, OBD–
Alientech KESS3OBD, Bench, Boot–
Alientech PowergateOBD–
Flashtec CMDOBD, Bench, Boot–
PCMflashBoot–

Also listed for this vehicle: Alientech KESSv2, ByteShooter Toolbox.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Mini One / One D / Minimalist 1.6 D tuning file

ECU and TCU files for the Mini One / One D / Minimalist R56 2010 - 2014 1.6 D (90 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Diesel
Displacement
1598 cc
Stock power
90 hp / 67 kW
Stock torque
215 Nm
ECU
Bosch EDC16C35, Bosch EDC17C41, Bosch EDC17C41 Exx, Bosch EDC17C50

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp