Chiptuning files » Mercedes-Benz » R » 2006 - 2013 » 350 (272 hp / 350 Nm)

Chiptuning files for Mercedes-Benz R 2006 - 2013 350 (272 hp)

ECU: Bosch ME9.7 · TCU: Siemens/Continental 7G-Tronic VGS2-NAG2

272 HPstock power
350 Nmstock torque
203 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

Deactivations and fixes

What each modification does
Stage 1 for Mercedes-Benz R 350 (272 hp)
Software-only remap for a car with standard hardware. 272 hp to 294 hp and 350 Nm to 378 Nm.
Stage 2 BASE for Mercedes-Benz R 350 (272 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us. 272 hp to 308 hp and 350 Nm to 397 Nm.
E85 or other special fuels modification for Mercedes-Benz R 350 (272 hp)
The calibration is set up for one special fuel, for example E85. This is not a flex-fuel setup.
Pops and bangs for Mercedes-Benz R 350 (272 hp)
Fuel still injected on overrun ignites in the exhaust and gives the crackle sound. Intensity can be set: soft (burbles), normal, hard or flames.
VMAX speedlimit on/off higher/lower for Mercedes-Benz R 350 (272 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Mercedes-Benz R 350 (272 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Cold start off - Catalyst heating off for Mercedes-Benz R 350 (272 hp)
The catalyst-heating phase after a cold start (raised idle, retarded ignition) is removed.
Catalyst off for Mercedes-Benz R 350 (272 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
EVAP off for Mercedes-Benz R 350 (272 hp)
Monitoring of the fuel vapour (EVAP) system is switched off.
SAI off for Mercedes-Benz R 350 (272 hp)
The secondary air injection system is switched off in software.
Virginize (ECU/TCU) for Mercedes-Benz R 350 (272 hp)
The unit is reset to an unpaired state so it can be coded to another car. A different service from IMMO_OFF.
Cloning (ECU/TCU) for Mercedes-Benz R 350 (272 hp)
The complete content of one unit is copied to another unit of the same type.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 170 credits (€98)
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
E85 or other special fuels modification120 credits (€168)+ 120 credits (€168)
Pops and bangs70 credits (€98)+ 40 credits (€56)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Cold start off - Catalyst heating off50 credits (€70)+ 50 credits (€70)
Catalyst off40 credits (€56)+ 20 credits (€28)
EVAP off40 credits (€56)+ 40 credits (€56)
SAI off40 credits (€56)+ 40 credits (€56)
Virginize (ECU/TCU)99 credits (€138.60)–
Cloning (ECU/TCU)199 credits (€278.60)–

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerOBD–
Magicmotorsport FLEXBoot, OBDOBD
Alientech KESS3OBD, Boot–
Alientech PowergateOBD–
Flashtec CMDOBD, BDMOBD
PCMflashOBD, Boot–
Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Mercedes-Benz R 350 tuning file

ECU and TCU files for the Mercedes-Benz R 2006 - 2013 350 (272 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Petrol
Engine code
M272
Stock power
272 hp / 203 kW
Stock torque
350 Nm
ECU
Bosch ME9.7
TCU
Siemens/Continental 7G-Tronic VGS2-NAG2

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp