Chiptuning files » BMW » Z4 » E85 2003 2009 » 35i - N54 (306 hp / 400 Nm)

Chiptuning files for BMW Z4 E85 2003 2009 35i - N54 (306 hp)

ECU: Bosch MEVD17.2.6

306 HPstock power
400 Nmstock torque
228 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

Immobiliser and cloning

What each modification does
Stage 1 for BMW Z4 35i - N54 (306 hp)
Software-only remap for a car with standard hardware. 306 hp to 366 hp and 400 Nm to 496 Nm.
Stage 2 BASE for BMW Z4 35i - N54 (306 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us. 306 hp to 390 hp and 400 Nm to 540 Nm.
Pops and bangs for BMW Z4 35i - N54 (306 hp)
Fuel still injected on overrun ignites in the exhaust and gives the crackle sound. Intensity can be set: soft (burbles), normal, hard or flames.
Sport displays calibration for BMW Z4 35i - N54 (306 hp)
The power and torque displays are recalibrated to the tuned values.
VMAX speedlimit on/off higher/lower for BMW Z4 35i - N54 (306 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for BMW Z4 35i - N54 (306 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Start/Stop System Off for BMW Z4 35i - N54 (306 hp)
Start-stop is switched off by default.
Cold start off - Catalyst heating off for BMW Z4 35i - N54 (306 hp)
The catalyst-heating phase after a cold start (raised idle, retarded ignition) is removed.
Exhaust flap control/off for BMW Z4 35i - N54 (306 hp)
Exhaust valves can be opened or closed independent of the driving mode. For cars with valves in the original exhaust.
Catalyst off for BMW Z4 35i - N54 (306 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
EVAP off for BMW Z4 35i - N54 (306 hp)
Monitoring of the fuel vapour (EVAP) system is switched off.
AGS off for BMW Z4 35i - N54 (306 hp)
The active grille shutters are switched off in software.
Torque monitoring off for BMW Z4 35i - N54 (306 hp)
Torque monitoring is relaxed so a higher torque does not trigger limp mode.
Readiness ok for BMW Z4 35i - N54 (306 hp)
Readiness monitors are set so the car reports ready at an emission inspection.
IMMO_OFF for BMW Z4 35i - N54 (306 hp)
The immobiliser check is removed from the ECU, so the engine starts without the immobiliser.
Cloning (ECU/TCU) for BMW Z4 35i - N54 (306 hp)
The complete content of one unit is copied to another unit of the same type.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 160 to 70 credits (€84 to €98), by model year
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
Pops and bangs70 credits (€98)+ 40 credits (€56)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Start/Stop System Off40 credits (€56)+ 40 credits (€56)
Cold start off - Catalyst heating off50 credits (€70)+ 50 credits (€70)
Exhaust flap control/off45 credits (€63)+ 45 credits (€63)
Catalyst off40 credits (€56)+ 20 credits (€28)
EVAP off40 credits (€56)+ 40 credits (€56)
AGS off30 credits (€42)+ 30 credits (€42)
Readiness ok45 credits (€63)+ 15 credits (€21)
IMMO_OFF99 credits (€138.60)+ 99 credits (€138.60)
Cloning (ECU/TCU)199 credits (€278.60)–

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
Alientech KESS3OBD, Boot–
Alientech PowergateOBD–
Flashtec CMDBench–
PCMflashBoot–
Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

BMW Z4 35i - N54 tuning file

ECU and TCU files for the BMW Z4 E85 2003 2009 35i - N54 (306 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Petrol
Engine code
N54B30A
Displacement
2979 cc
Stock power
306 hp / 228 kW
Stock torque
400 Nm
ECU
Bosch MEVD17.2.6

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp