Chiptuning files » Audi » RS7 » C7 2010 2018 » 'Performance' (605 hp / 750 Nm)

Chiptuning files for Audi RS7 C7 2010 2018 'Performance' (605 hp)

ECU: Bosch MED17.1 / Bosch MED17.1.1 · TCU: ZF AL450 / ZF ALx51

605 HPstock power
750 Nmstock torque
451 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

Immobiliser and cloning

What each modification does
Stage 1 for Audi RS7 'Performance' (605 hp)
Software-only remap for a car with standard hardware. 605 hp to 677 hp and 750 Nm to 897 Nm.
Stage 2 BASE for Audi RS7 'Performance' (605 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us. 605 hp to 725 hp and 750 Nm to 1005 Nm.
E85 or other special fuels modification for Audi RS7 'Performance' (605 hp)
The calibration is set up for one special fuel, for example E85. This is not a flex-fuel setup.
Gearbox TCU tuning for Audi RS7 'Performance' (605 hp)
Faster shift times, modified shift points, raised torque limiters, raised rpm limits and higher clutch pressure where needed.
Pops and bangs for Audi RS7 'Performance' (605 hp)
Fuel still injected on overrun ignites in the exhaust and gives the crackle sound. Intensity can be set: soft (burbles), normal, hard or flames.
Hardcut limiter for Audi RS7 'Performance' (605 hp)
Ignition is cut at the limiter instead of fuel being reduced early, so full power is available to the redline.
VMAX speedlimit on/off higher/lower for Audi RS7 'Performance' (605 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Audi RS7 'Performance' (605 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Start/Stop System Off for Audi RS7 'Performance' (605 hp)
Start-stop is switched off by default.
Cold start off - Catalyst heating off for Audi RS7 'Performance' (605 hp)
The catalyst-heating phase after a cold start (raised idle, retarded ignition) is removed.
Exhaust flap control/off for Audi RS7 'Performance' (605 hp)
Exhaust valves can be opened or closed independent of the driving mode. For cars with valves in the original exhaust.
Catalyst off for Audi RS7 'Performance' (605 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
EVAP off for Audi RS7 'Performance' (605 hp)
Monitoring of the fuel vapour (EVAP) system is switched off.
SAI off for Audi RS7 'Performance' (605 hp)
The secondary air injection system is switched off in software.
Cylinder On Demand off for Audi RS7 'Performance' (605 hp)
Cylinder deactivation is switched off so the engine always runs on all cylinders.
Torque monitoring off for Audi RS7 'Performance' (605 hp)
Torque monitoring is relaxed so a higher torque does not trigger limp mode.
Readiness ok for Audi RS7 'Performance' (605 hp)
Readiness monitors are set so the car reports ready at an emission inspection.
Boost Sensor Calibration for Audi RS7 'Performance' (605 hp)
Calibration for an uprated boost pressure (MAP) sensor.
RPM Limit Mod for Audi RS7 'Performance' (605 hp)
The engine speed limit is raised or lowered.
IMMO_OFF for Audi RS7 'Performance' (605 hp)
The immobiliser check is removed from the ECU, so the engine starts without the immobiliser.
Cloning (ECU/TCU) for Audi RS7 'Performance' (605 hp)
The complete content of one unit is copied to another unit of the same type.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 170 to 80 credits (€98 to €112), by model year
Stage 2 BASE90 credits (€126)
Gearbox TCU tuning Stage 1 BASIC75 credits (€105)
Gearbox TCU tuning Stage 199 credits (€138.60)
Gearbox TCU tuning Stage 2 BASE150 credits (€210)
Gearbox TCU tuning Stage 3 BASE195 credits (€273)

Options

OptionOrdered on its ownAdded to a Stage 1 file
E85 or other special fuels modification120 credits (€168)+ 120 credits (€168)
Pops and bangs70 credits (€98)+ 40 credits (€56)
Hardcut limiter55 to 65 credits (€77 to €91), by model year+ 55 credits (€77)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Start/Stop System Off40 credits (€56)+ 40 credits (€56)
Cold start off - Catalyst heating off50 credits (€70)+ 50 credits (€70)
Exhaust flap control/off45 to 55 credits (€63 to €77), by model year+ 45 credits (€63)
Catalyst off40 credits (€56)+ 20 credits (€28)
EVAP off40 to 50 credits (€56 to €70), by model year+ 40 credits (€56)
SAI off40 credits (€56)+ 40 credits (€56)
Cylinder On Demand off25 credits (€35)+ 25 credits (€35)
Readiness ok45 credits (€63)+ 15 credits (€21)
Boost Sensor Calibration55 to 65 credits (€77 to €91), by model year+ 55 credits (€77)
RPM Limit Mod45 credits (€63)included
IMMO_OFF99 credits (€138.60)+ 99 credits (€138.60)
Cloning (ECU/TCU)199 credits (€278.60)–

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerBench, Boot, OBDBench (beta), OBD
Magicmotorsport FLEXBench, Boot, OBDBench, OBD
Alientech KESS3OBD, Bench, BootOBD, Bench
Alientech PowergateOBD–
Flashtec CMDBench, Boot–
PCMflashOBD, BootOBD

Also listed for this vehicle: Alientech KESSv2, Dimsport New Genius.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Audi RS7 'Performance' tuning file

ECU and TCU files for the Audi RS7 C7 2010 2018 'Performance' (605 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Petrol
Engine code
CWUC
Displacement
3993 cc
Stock power
605 hp / 451 kW
Stock torque
750 Nm
ECU
Bosch MED17.1, Bosch MED17.1.1
TCU
ZF AL450, ZF ALx51

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp