Chiptuning files » Audi » A6 » C5 1997 - 2004 » 3.0 V6 (220 hp / 300 Nm)

Chiptuning files for Audi A6 C5 1997 - 2004 3.0 V6 (220 hp)

ECU: Bosch ME7.1 · TCU: Temic VL300

StockStage 1 (+ 18 HP)

220 HPstock power

300 Nmstock torque

164 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

What each modification does

Stage 1 for Audi A6 3.0 V6 (220 hp): Software-only remap for a car with standard hardware. 220 hp to 238 hp and 300 Nm to 323 Nm.
Stage 2 BASE for Audi A6 3.0 V6 (220 hp): Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us.
Flex fuel mod for E85 or other fuel types for Audi A6 3.0 V6 (220 hp): The engine adapts to the fuel that is in the tank, from petrol to E85 and any blend in between. This is not a fixed E85 calibration.
Gearbox TCU tuning for Audi A6 3.0 V6 (220 hp): Faster shift times, modified shift points, raised torque limiters, raised rpm limits and higher clutch pressure where needed.
Pops and bangs for Audi A6 3.0 V6 (220 hp): Fuel still injected on overrun ignites in the exhaust and gives the crackle sound. Intensity can be set: soft (burbles), normal, hard or flames.
VMAX speedlimit on/off higher/lower for Audi A6 3.0 V6 (220 hp): The electronic speed limiter is removed, raised or lowered.
DTC off for Audi A6 3.0 V6 (220 hp): Selected fault codes are switched off so they are no longer stored or shown.
Start/Stop System Off for Audi A6 3.0 V6 (220 hp): Start-stop is switched off by default.
Cold start off - Catalyst heating off for Audi A6 3.0 V6 (220 hp): The catalyst-heating phase after a cold start (raised idle, retarded ignition) is removed.
Catalyst off for Audi A6 3.0 V6 (220 hp): Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
EVAP off for Audi A6 3.0 V6 (220 hp): Monitoring of the fuel vapour (EVAP) system is switched off.
SAI off for Audi A6 3.0 V6 (220 hp): The secondary air injection system is switched off in software.
Readiness ok for Audi A6 3.0 V6 (220 hp): Readiness monitors are set so the car reports ready at an emission inspection.
IMMO_OFF for Audi A6 3.0 V6 (220 hp): The immobiliser check is removed from the ECU, so the engine starts without the immobiliser.
Cloning (ECU/TCU) for Audi A6 3.0 V6 (220 hp): The complete content of one unit is copied to another unit of the same type.
Checksum Correction for Audi A6 3.0 V6 (220 hp): The checksums of the file are recalculated so the control unit accepts the modified software.
Anti lag for Audi A6 3.0 V6 (220 hp): Boost is kept up when you lift off the throttle, so the turbo responds sooner when you accelerate again.

Prices for this vehicle

Pay with

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning file	Price
Stage 1	60 credits (€84)
Stage 2 BASE	90 credits (€126)
Gearbox TCU tuning Stage 1 BASIC	75 credits (€105)
Gearbox TCU tuning Stage 1	99 credits (€138.60)
Gearbox TCU tuning Stage 2 BASE	150 credits (€210)
Gearbox TCU tuning Stage 3 BASE	195 credits (€273)

Options

Option	Ordered on its own	Added to a Stage 1 file
Flex fuel mod for E85 or other fuel types	150 credits (€210)	+ 150 credits (€210)
Pops and bangs	70 credits (€98)	+ 40 credits (€56)
VMAX speedlimit on/off higher/lower	40 credits (€56)	included
DTC off	45 credits (€63)	+ 30 credits (€42)
Start/Stop System Off	40 credits (€56)	+ 40 credits (€56)
Cold start off - Catalyst heating off	50 credits (€70)	+ 50 credits (€70)
Catalyst off	40 credits (€56)	+ 20 credits (€28)
EVAP off	40 credits (€56)	+ 40 credits (€56)
SAI off	40 credits (€56)	+ 40 credits (€56)
Readiness ok	45 credits (€63)	+ 15 credits (€21)
IMMO_OFF	99 credits (€138.60)	+ 99 credits (€138.60)
Cloning (ECU/TCU)	199 credits (€278.60)	–
Checksum Correction	10 credits (€14)	+ 10 credits (€14)

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

Tool	ECU read method	TCU read method
Magicmotorsport FLEX	–	OBD
Alientech KESS3	OBD, Boot	–
Alientech Powergate	OBD	–
PCMflash	–	OBD, Boot

Also listed for this vehicle: Alientech KESSv2.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.