Chiptuning files » Ford » C-Max » I 2003 2010 » 1.6 TDCi (90 hp / 204 Nm)

Chiptuning files for Ford C-Max I 2003 2010 1.6 TDCi (90 hp)

ECU: Bosch EDC16C3 / Bosch EDC16C34

90 HPstock power
204 Nmstock torque
67 KWstock power

Select a stage for the tuned figures and the power and torque curve.

Available modifications

Engine performance

What each modification does
Stage 1 for Ford C-Max 1.6 TDCi (90 hp)
Software-only remap for a car with standard hardware. 90 hp to 117 hp and 204 Nm to 252 Nm.
Stage 2 BASE for Ford C-Max 1.6 TDCi (90 hp)
Remap matched to hardware upgrades. Which parts are needed differs per engine. If needed we fine-tune the file up to 3 times free of charge, based on the datalogs you send us.
Hardcut Popcorn limiter for diesel for Ford C-Max 1.6 TDCi (90 hp)
Hard-cut rev limiter for diesel engines with the typical popcorn sound.
VMAX speedlimit on/off higher/lower for Ford C-Max 1.6 TDCi (90 hp)
The electronic speed limiter is removed, raised or lowered.
DTC off for Ford C-Max 1.6 TDCi (90 hp)
Selected fault codes are switched off so they are no longer stored or shown.
Catalyst off for Ford C-Max 1.6 TDCi (90 hp)
Catalyst monitoring by the lambda (O2) sensor is switched off so a sport catalyst or decat does not raise fault codes.
DPF/OPF/GPF off for Ford C-Max 1.6 TDCi (90 hp)
The particulate filter function (diesel DPF, petrol OPF/GPF) is switched off in software. The filter has to be removed physically first.
Swirl flaps off for Ford C-Max 1.6 TDCi (90 hp)
Intake flap operation is switched off for engines where the flaps have been removed.
EGR off for Ford C-Max 1.6 TDCi (90 hp)
The exhaust gas recirculation valve is switched off in software.
AdBlue off for Ford C-Max 1.6 TDCi (90 hp)
The SCR / AdBlue system is switched off in software.
MAF off for Ford C-Max 1.6 TDCi (90 hp)
The engine runs without the air mass meter signal.
TVA off for Ford C-Max 1.6 TDCi (90 hp)
The throttle valve actuator is switched off in software.
Readiness ok for Ford C-Max 1.6 TDCi (90 hp)
Readiness monitors are set so the car reports ready at an emission inspection.
Hot start fix for Ford C-Max 1.6 TDCi (90 hp)
Corrects hard starting with a hot engine.
Boost Sensor Calibration for Ford C-Max 1.6 TDCi (90 hp)
Calibration for an uprated boost pressure (MAP) sensor.
Virginize (ECU/TCU) for Ford C-Max 1.6 TDCi (90 hp)
The unit is reset to an unpaired state so it can be coded to another car. A different service from IMMO_OFF.
Cloning (ECU/TCU) for Ford C-Max 1.6 TDCi (90 hp)
The complete content of one unit is copied to another unit of the same type.
Checksum Correction for Ford C-Max 1.6 TDCi (90 hp)
The checksums of the file are recalculated so the control unit accepts the modified software.
Idle RPM Mod for Ford C-Max 1.6 TDCi (90 hp)
The idle speed is raised or lowered; the rev limit can be changed as well.
Smoke test fix for Ford C-Max 1.6 TDCi (90 hp)
The calibration is adjusted for the diesel smoke (opacity) test.

Prices for this vehicle

Prices shown for single credits. Choose a credit pack to see how much cheaper it is; unused credits stay in your account for other projects. Prices for cars. Prices are set in euro.

Tuning filePrice
Stage 160 to 70 credits (€84 to €98), by model year
Stage 2 BASE90 credits (€126)

Options

OptionOrdered on its ownAdded to a Stage 1 file
Hardcut Popcorn limiter for diesel55 credits (€77)+ 40 credits (€56)
VMAX speedlimit on/off higher/lower40 credits (€56)included
DTC off45 credits (€63)+ 30 credits (€42)
Catalyst off40 credits (€56)+ 20 credits (€28)
DPF/OPF/GPF off50 credits (€70)+ 35 credits (€49)
Swirl flaps off45 credits (€63)+ 45 credits (€63)
EGR off35 credits (€49)+ 30 credits (€42)
AdBlue off60 credits (€84)+ 60 credits (€84)
MAF off45 credits (€63)–
TVA off40 credits (€56)+ 40 credits (€56)
Readiness ok45 credits (€63)+ 15 credits (€21)
Hot start fix35 credits (€49)+ 35 credits (€49)
Boost Sensor Calibration55 credits (€77)+ 55 credits (€77)
Virginize (ECU/TCU)99 credits (€138.60)–
Cloning (ECU/TCU)199 credits (€278.60)–
Checksum Correction10 credits (€14)+ 10 credits (€14)
Idle RPM Mod45 credits (€63)+ 45 credits (€63)

Most options cost less when you add them to a stage file than when you order them on their own.

Tools to read this vehicle

ToolECU read methodTCU read method
AutotunerBench, OBD–
Magicmotorsport FLEXBench, Boot, OBD–
Alientech KESS3OBD, Bench, Boot–
Alientech PowergateOBD–
Flashtec CMDOBD, Bench, BDM–
PCMflashBoot–

Also listed for this vehicle: Alientech KESSv2.

Results vary per vehicle, and what is possible can differ per software version. This applies to every modification we deliver, for the ECU and for the TCU. Upload your original file to check what is available for your vehicle.

Ford C-Max 1.6 TDCi tuning file

ECU and TCU files for the Ford C-Max I 2003 2010 1.6 TDCi (90 hp).

Stage 1 on average in 50 minutes.

Upload your original file

Prices for this vehicle

Engine and control units

Fuel
Diesel
Engine code
HHDA / HHDB
Displacement
1560 cc
Stock power
90 hp / 67 kW
Stock torque
204 Nm
ECU
Bosch EDC16C3, Bosch EDC16C34

We walk the extra mile.

Full throttle to the solution

Continuously improving

We regularly make improvements to existing files.

Fast response times

We are easy to reach and respond quickly to all your questions.

Developed on dyno

Many of our tuning files are carefully tested on dyno and road.

We are here to help you

Our engineers are highly skilled and have many years of experience in calibrating engines and gearboxes. They are here to answer your questions.

ECUFILES engineer at work

2512 real customers worldwide

QS RACINGGuosong Huang
★★★★★

I like your team. Because we have cooperated for 4 years.

Ecufiles response: Thanks a lot for your compliment and for already working with us for the last 4 years.

Antonis Markou GarageMarkou Constantinos
★★★★★

I am very happy to meet you guys and I love working with you! Keep going !

Ecufiles response: Dear Antonis, Thanks a lot for your compliments.

All reviews

Technical Questions
For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

Sales Questions
For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

Response time: Quick!

For sales questions, you can also reach us at:

WhatsApp: +31686247602

Response time: Moderate!

WhatsApp