Technical Description of OBD-II Trouble Code
Intermittent Shift Solenoid H
What does that signify?
This is a generic diagnostic trouble code (DTC) for transmission issues and is commonly found in OBD-II vehicles with automatic transmissions.
This can apply to various vehicles including those from Chrysler, Ford, Dodge, Hyundai, Kia, Ram, Lexus, Toyota, Mazda, Honda, VW, etc. While the general steps for repair may vary depending on the year, make, model, and powertrain configuration, the code is applicable.
Most automatic transmissions have multiple shift solenoids, depending on the number of gears. The trouble codes associated with the “H” solenoid are P076A, P076B, P076C, P076D, and P076E. These codes indicate specific malfunctions that trigger the PCM to set the code and illuminate the Check Engine Light. If your vehicle has an Overdrive or other transmission warning lamp, it may also be illuminated.
The purpose of the Shift Solenoid Circuit is for the PCM to monitor the shift solenoids, manage fluid movement between hydraulic circuits, and change the transmission gear ratio at the appropriate time. This process optimizes engine performance at the lowest RPM possible.
Automatic transmissions rely on bands and clutches to change gears, which requires proper fluid pressure. The transmission solenoids open or close valves in the valve body to allow transmission fluid to flow to the clutches and bands, ensuring smooth shifting as the engine accelerates.
When the Powertrain Control Module (PCM) detects a malfunction in the Shift Solenoid “H” Shift Circuit, various codes can be triggered depending on the specific vehicle, transmission, and number of gears. In this case, the P076E OBD-II trouble code is associated with an intermittent fault in the transmission Shift Solenoid “H” Circuit.
Example of shift solenoids:
What is the severity of this DTC?
Initially, the severity of this code is moderate, but if not corrected promptly, it can escalate to a more severe level.
What are some of the symptoms of the code?
Symptoms of a P076E trouble code may include:
What are some of the common causes of the code?
Possible causes for this P076E transmission code may include:
What are some P076E troubleshooting steps?
Prior to troubleshooting, it is recommended to research the Technical Service Bulletins (TSB’s) for the specific vehicle by year, model, and transmission. This can save time by providing guidance in the right direction. Additionally, checking the vehicle records to verify the last time the filter and fluid were changed is advisable.
Fluid & Wiring Inspections
Begin by ensuring the fluid level is correct and inspecting the fluid for contamination. Then, visually inspect the associated wiring for any obvious defects such as scraping, rubbing, bare wires, or burn spots.
Next, check the connectors and connections for security, corrosion, and damaged pins. This includes all wiring and connectors to the transmission solenoids, transmission pump, and the PCM. Additionally, inspect the transmission linkage for security and binding issues based on the configuration.
Advanced Steps
The advanced steps are specific to each vehicle and require appropriate advanced equipment for accurate performance. These procedures involve using a digital multimeter and referencing the specific technical data for the vehicle. Voltage requirements will vary based on the specific year and model. It is important to follow the specific troubleshooting chart for the vehicle.
Continuity Checks
Always perform continuity checks with the power removed from the circuit. The normal readings for wiring and connections should be 0 ohms of resistance unless otherwise specified by the technical data. Resistance or no continuity indicates faulty wiring that is open or shorted and must be repaired or replaced.
What are some common repairs for this code?
We always recommend seeking professional service to address this issue. However, if that is not possible, we offer the option to permanently delete this specific DTC while keeping all other codes active. If you are interested in this option, please upload your ECU file to our portal.
