Technical Description of OBD-II Trouble Code
Bank 1 NOx Sensor Circuit
What does that signify?
This is a standard diagnostic trouble code (DTC) for powertrain issues and is commonly found in OBD-II vehicles. This can apply to various vehicle brands such as Ford, Mercedes Benz, BMW, VW, Audi, Chevrolet, GMC, Dodge, Ram, Sprinter, and more. While it is a generic code, the specific repair steps may vary depending on the year, make, model, and powertrain configuration of the vehicle.
In general, diesel-fueled engines produce higher levels of particulate matter (PM) and Nitrogen Oxide (NOx) emissions compared to gasoline engines.
As vehicle emission standards have evolved, engineers have been developing methods to reduce atmospheric emissions in order to comply with and exceed emission requirements set by state/provincial laws.
The Engine Control Module (ECM) constantly monitors numerous sensors to ensure the efficiency, reliability, and functionality of the engine. It also actively monitors emissions to minimize the release of hydrocarbons into the atmosphere. The NOx sensor is used by the ECM to measure nitrogen oxide levels in the exhaust and determine the amount of hydrocarbons being emitted. NOx is a primary particulate matter produced by diesel engines. The ECM continuously monitors this sensor and adjusts the system accordingly.
It is important to note that the exhaust of a diesel engine is a highly contaminated area. The soot produced by the exhaust can accumulate on sensors and switches, potentially affecting their performance. This becomes significant because if the sensor is obstructed, it may not accurately measure the values required by the ECM to adjust the EVAP (Evaporative Emissions) system in accordance with federal/state/provincial laws. In some cases, aftermarket sensors are used to comply with local emission standards when traveling between states with different regulations.
The ECM triggers the P2200 code and related codes (P2201, P2202, P2203, and P2204) when it detects a fault in the NOx sensors or their circuits. Although I have limited experience with this code, it is likely that mechanical issues are often the cause, especially considering the conditions mentioned earlier.
The P2200 code is set when the ECM identifies a fault in the bank #1 NOx sensor or circuit.
Note: In engines with multiple banks of cylinders (e.g. V6, V8), bank 1 refers to the side of the engine that contains the #1 cylinder. Therefore, the NOx sensor is located in the exhaust of that bank. Refer to your service manual for specific information regarding your make, model, and powertrain. The service manual is the primary resource for identifying the specific sensor among the various options. Similar distinctions are made for O2 (oxygen) sensors.
Here is an example of a NOx sensor for GM vehicles:
What is the severity of this DTC?
In most cases, emission-related codes are relatively low on the severity scale, especially when compared to potential hazards in other vehicle systems such as steering, suspension, and brakes. If you have more pressing issues to address, you can prioritize those over this code. However, it is important to address any electrical faults with a sense of urgency.
What are some of the symptoms of the code?
Some symptoms of a P2200 trouble code may include:
What are some of the common causes of the code?
Possible causes for this P2200 fuel trim code may include:
What are some P2200 troubleshooting steps?
Start by visually inspecting the sensor and its harness. Sometimes, external elements can cause faults. I have seen sensors like these damaged by rocks, curbs, snow, and ice, so ensure that the sensor is intact and in good condition. Keep in mind that some harnesses may be located close to the exhaust, which increases the risk of wires getting burnt or melted and causing various problems.
TIP: Allow the engine to cool before working near the exhaust.
Clean the sensor. It is important to note that sensors mounted in the exhaust undergo numerous heating and cooling cycles. As a result, they may become stuck in the sensor “bung” (thread hole) on the exhaust. If this happens, you may need to apply heat to the threads, but avoid direct heat on the sensor itself to prevent damage. If you are not experienced in using heat to loosen nuts or bolts, I recommend seeking assistance from a reputable service station.
