Technical Description of OBD-II Trouble Code
The control circuit for Pressure Control Solenoid C is open.
What does that mean?
This is a generic diagnostic trouble code (DTC) for transmissions and applies to OBD-II vehicles with automatic transmissions. This includes vehicles from various manufacturers such as Ford, GMC, Chevrolet, Honda, BMW, Saturn, Land Rover, Acura, Nissan, Saturn, etc. Although it is a generic code, the specific repair steps may vary depending on the year, make, model, and powertrain configuration of the vehicle.
Most automatic transmissions have at least three pressure control solenoids, labeled A, B, and C. Newer transmissions may have more solenoids and gears. The “C” solenoid control circuit is associated with various trouble codes, including P0968, P0969, P0970, and P0971. When the P0968 code is set, it means that the Powertrain Control Module (PCM) has detected a problem with the transmission pressure control solenoid “C” control circuit. The specific code set depends on the specific malfunction detected by the PCM.
An automatic transmission relies on bands and clutches that change gears by maintaining fluid pressure in the right place at the right time. The purpose of the transmission pressure control solenoids is to adjust the fluid pressure for the transmission to operate properly and shift smoothly. The PCM monitors the pressure within the solenoids and directs fluid to different hydraulic circuits to change the transmission gear ratio as needed.
Code P0968 is set when the PCM detects that the control circuit for the “C” pressure control solenoid is open.
Example of transmission solenoids:
What is the severity of this DTC?
This code typically starts as a moderate severity, but if not corrected promptly, it can quickly escalate to a more severe level. If the transmission bangs into gear, it can cause permanent internal damage, making the problem a severe issue.
What are some of the symptoms of the code?
Symptoms of a P0968 trouble code may include:
What are some of the common causes of the code?
Possible causes for this P0968 transmission code may include:
What are some P0968 troubleshooting steps?
Prior to troubleshooting any malfunction, it is recommended to research the Technical Service Bulletins (TSB’s) for the specific vehicle based on the year, model, and transmission. This can save time by providing guidance in the right direction.
Fluid & Wiring Inspections
The first step is to check the fluid level and examine the condition of the fluid for contamination. Before changing the fluid, it is advisable to check the vehicle records to verify when the filter and fluid were last changed.
Next, perform a detailed visual inspection to check the condition of the wiring for any obvious defects. Check the connectors and connections for security, corrosion, and damaged pins. This includes all wiring and connectors related to the transmission pressure control solenoids, transmission pump, and PCM. Depending on the specific configuration, the transmission pump may be driven electrically or mechanically.
Advanced Steps
The advanced steps are highly vehicle-specific and require specialized equipment for accurate performance. These procedures involve using a digital multimeter and specific technical references for the vehicle. It is important to obtain the specific troubleshooting data for the vehicle before proceeding with the advanced steps. Voltage requirements and fluid pressure requirements may vary based on the specific model and transmission design.
Continuity Checks
Unless otherwise specified by the technical data, the normal readings for wiring and connections should be 0 ohms of resistance. Continuity checks should always be performed with the power removed from the circuit to avoid shorting the circuit and causing further damage. Resistance or no continuity indicates faulty wiring that is open or shorted and must be repaired or replaced.
What are some common repairs for this code?
Possible misdiagnosis may include:
We always recommend seeking professional mechanical service to solve this issue. However, if that is not possible, we offer the option to permanently delete this specific DTC while keeping all other codes active. If you are interested in this option, please upload your ECU file to our portal.
