P0599 Thermostat Heater Control Circuit High

Technical Description of OBD-II Trouble Code

The thermostat heater control circuit is experiencing high voltage.

What does that mean?

This is a generic powertrain diagnostic trouble code (DTC) that applies to all makes and models from 1996 onwards. However, the specific troubleshooting steps may vary depending on the vehicle.

The codes P0597, P0598, and P0599 all refer to an electronically controlled engine thermostat. These codes are generic and apply to all vehicles that use this type of thermostatic control. However, only a small number of manufacturers utilize this system. Therefore, this trouble code article is essentially the same for all three codes.

The P0599 code indicates a fault in the system where the control voltage is high. This system is primarily used in German manufactured vehicles such as BMW, Mercedes, Audi, Mini, Volkswagen, Opel, and Jaguar.

The electronically controlled thermostat consists of various temperature and load sensors, a computer program, and the control housing with a built-in thermostat.

Concept

By electronically controlling the coolant flow or engine temperature, fuel economy can be increased and emissions can be reduced during part throttle, while reducing the temperature under load can increase power.

Symptoms

The symptoms of a P0599 code will vary depending on the position of the thermostat at the time of failure. However, it is unlikely that there will be any noticeable difference in the operation of the vehicle.

  • The check engine light will illuminate and one of the above codes will be set
  • If the thermostat failed in the partially closed position, the temperature gauge may read abnormally high. Conversely, if the thermostat failed in the fully open position, the temperature gauge will read lower than normal.
  • Potential Causes

    Based on experience, the problem usually lies in a loose or corroded electrical connector, or the electrically operated thermostat itself is faulty. Occasionally, the Motronic (engine management) computer may fail, but this is the least likely cause.

  • A loose or corroded connector on the thermostat
  • A coolant leak that causes the code to be set
  • A failed thermostat
  • A short or open in the wiring harness between the computer and thermostat
  • The Motronic computer has failed
  • Diagnostic and Repair Procedures

  • Remove and inspect the electrical connector. Remove any corrosion using baking soda or by scraping. Apply electro grease and ensure a tight connection.
  • Inspect the coolant level in the radiator. Low coolant levels can cause the electronic thermostat to overheat and set a code.
  • Remove the electrical connector and check the resistance values on the thermostat. You will need a service manual or find the necessary information online for this procedure.
  • This information should include the identification of the pins and their location, wire colors, pin values in volts at specific temperatures, and resistances. These values and diagnostic procedures may vary depending on the manufacturer and engine size.

    You will also need an infrared temperature probe and a volt/ohmmeter.

  • Determine the temperature of the engine using the temperature probe
  • Start the engine and test the voltage on the Motronic side of the harness according to the instructions. If it is within limits, continue testing. If there was no voltage or it was out of range, replace the Motronic unit
  • Compare the resistance on the thermostat side of the harness at the thermostat. If the resistance is out of range, replace the thermostatic unit
  • If the necessary tools are not readily available, take the vehicle to a reputable shop that has access to the required information. This is a simple diagnosis with the correct tools
  • Professional Service Options

    When facing p0599 error, you have two solutions:

    Option 1: Mechanical Repair (Recommended)

    We highly recommend solving this issue by repairing or replacing the faulty sensor, wiring, or related mechanical parts.
    This ensures your vehicle operates as designed.

    Option 2: Permanent p0599 DTC Deletion (Alternative)

    If mechanical repair is not possible, we offer a professional service to permanently delete p0599 trouble code (DTC) from your ECU.

    Instantly Fix Your DTC Problem – No Hardware Changes Needed!

    Get your p0599 code permanently deleted by our experts.

    ✅ Fast. ✅ Reliable. ✅ Keeps your vehicle running smoothly.

    🔥 Upload your ECU file and start now! 🔥

    Already a member? Log in here to submit your file!

    Tuning Files Service from ECUFILES

    Custom Tuning File Service

    EVC Reseller Database

    Automatic File Service

    Technical Questions
    For technical questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

    Response time: Quick!

    Sales Questions
    For sales questions, please register for free and submit a ticket on our platform. One of our engineers will respond to you as soon as possible during business hours.

    Response time: Quick!

    For sales questions, you can also reach us at:

    WhatsApp: +31686247602

    Response time: Moderate!

    WhatsApp