Technical Description
Intermittent or erratic circuit for Mass or Volume Air Flow “B”
What does that mean?
This diagnostic trouble code (DTC) is a generic powertrain code that applies to vehicles equipped with OBD-II and a mass airflow sensor. This includes brands such as Toyota, Infiniti, Nissan, Jaguar, Audi, Mercedes, Dodge, Hyundai, Chevy, Ford, etc. While the code is generic, the specific repair steps may vary depending on the make and model of the vehicle.
The MAF (mass air flow) sensor is located in the engine air intake tract downstream from the air filter. Its purpose is to measure the volume and density of air entering the engine. However, the MAF sensor only measures a portion of the air entering, and this value is used to calculate the total volume and density of air being ingested.
The powertrain control module (PCM) uses the MAF sensor reading, along with other sensor parameters, to ensure proper fuel delivery for optimal power and fuel efficiency.
This P010E diagnostic trouble code (DTC) indicates that there is an intermittent or erratic fault detected in the Mass Air Flow (MAF) B sensor or circuit. The PCM detects that the actual MAF sensor frequency signal is not within the normal expected range of the calculated MAF value. Consult a vehicle-specific repair manual to determine which circuit is the B circuit in your particular application.
Note: Some MAF sensors also include an air temperature sensor, which is another value used by the PCM for optimal engine operation.
Other closely related MAF circuit trouble codes include P010A, P010B, P010C, and P010D.
Photo of a MAF sensor:
What are some possible symptoms?
Symptoms of a P010E code may include:
What are some potential causes?
Potential causes for this trouble code may include:
Note that other codes may be present if you have a P010E. You may have misfire codes or O2 sensor codes, so it’s important to take a comprehensive look at how the systems work together and affect each other during diagnosis.
What can I do to diagnose and repair a P010E engine code?
If you need to replace the MAF sensor, we recommend using an original equipment OEM part from the manufacturer rather than an aftermarket part.
Note: The use of a reusable oiled air filter could be a cause of this code if it is over-oiled. Oil can transfer to the fine wire or film inside the MAF sensor and contaminate it. In such situations, use MAF cleaner spray to clean the MAF. We do not recommend using oiled air filters.
