Technical Description of OBD-II Trouble Code
The control circuit for Fuel Pressure Regulator 1 is experiencing high voltage.
What does that mean?
This diagnostic trouble code (DTC) is a generic powertrain code that applies to OBD-II equipped vehicles (Isuzu, Mazda, Dodge, Chrysler, Ford, GMC, Chevy, Toyota, Honda, etc.). While it is a generic code, the specific repair steps may vary depending on the make and model of the vehicle.
In my experience diagnosing a code P0092, it typically indicates that the powertrain control module (PCM) has detected a high voltage signal from the control circuit of the electronic fuel pressure regulator designated with a 1. Systems with multiple electronic fuel pressure regulators use numerical designations. It may refer to a specific engine bank, but not always.
The PCM is responsible for controlling the electronic fuel pressure regulator. Battery voltage and ground signals are used to control a servo motor in the fuel pressure regulator, which positions a valve to achieve the desired level of fuel pressure for any given situation. The PCM monitors the fuel pressure sensor, located in the fuel injector rail, in order to adjust the voltage of the fuel pressure regulator when necessary. Increasing the voltage opens the valve and increases fuel pressure, while decreasing the voltage closes the valve and decreases fuel pressure.
The fuel pressure regulator and fuel pressure sensor are often integrated into a single housing with one electrical connector, but they may also be separate components.
If the actual voltage of the fuel pressure regulator control circuit is lower than the expected degree calculated by the PCM, a P0092 code will be stored and the malfunction indicator lamp (MIL) may illuminate.
Related engine codes for the fuel pressure regulator:
Symptoms & Severity
A code P0092 should be considered severe because excessive fuel pressure can cause damage to the internal engine and catalytic converter, as well as various drivability issues.
Symptoms of a P0092 code may include:
Causes
Possible causes for this code to be set are:
Diagnostic and Repair Procedures
To diagnose a code P0092, you will need a diagnostic scanner, a digital volt/ohmmeter (DVOM), a suitable fuel pressure gauge, and a reliable vehicle information source (such as All Data DIY).
NOTE: Use extreme caution when using a manual fuel pressure gauge, as high pressure fuel contacting hot surfaces or open sparks could ignite and cause a fire.
In the past, I have found a visual inspection of the system wiring and connectors, with a focus on the harnesses and connectors on top of the engine, to be helpful. The warm upper engine area seems to attract pests, especially in cold climates, and they often chew on the system wiring and connectors.
Next, connect the scanner to the vehicle diagnostic port and retrieve stored codes and freeze frame data. It may be helpful to write down this information if the diagnostic process takes a while. Clear the codes and test-drive the vehicle if the engine starts.
If the code is reset, check for the correct voltage and battery ground at the fuel pressure regulator. If no voltage is found at the fuel pressure regulator connector, test the power supply relays and fuses by following the appropriate wiring diagram from the vehicle information source. If no ground is present, consult the wiring diagram to locate the fuel pressure regulator control system ground(s) and ensure they are secure.
If suitable voltage and ground circuits are discovered at the fuel pressure control regulator connector, obtain fuel pressure specifications from the vehicle information source and test the fuel system pressure using the fuel pressure gauge. Follow the manufacturer’s recommendations for using the fuel pressure gauge.
Monitor the manual fuel pressure with the fuel gauge while using the scanner to observe fuel system data. If the level of fuel pressure shown on the scanner does not match the actual fuel pressure, a defective fuel pressure sensor may be the cause. Fluctuations in fuel pressure regulator control voltage should correspond to fluctuations in actual fuel rail pressure. If not, suspect that either the fuel pressure regulator is defective, there is an open or shorted circuit in one of the fuel pressure regulator control circuits, or the PCM is faulty.
To test the electronic fuel pressure regulator and the individual fuel pressure regulator control circuits, use the DVOM and follow the manufacturer’s recommendations. Disconnect controllers from the circuit before testing circuit resistance and continuity with the DVOM.
Additional diagnostic notes:
Other fuel pressure trouble codes include:
